|
|
.gif) |
|
¡¡ |
Optical Node
OPS1000(E)
two-way optical node
The forward
receiver adopt the high performance active photoelectric
transform module with ORTEL technology, the RF amplifier adopt
the GaAs power multiplier gain module; and the reverse
transmitter adopt the high quality FP laser, the output power is
0~3dbm. In addition, the cost of this product reduced by
adopting the latest applied technique of the photoelectric
products. This product becomes much suitable for the HFC network
after times of improvement. The feed as well as the output form
are able to satisfy the requirement of different users.
|
|
|
|
Features
-
The forward receiver adopt the high
performance active photoelectric transform module with ORTEL
technology, and the reverse transmitter adopt the high
quality FP laser
-
The GaAs power multiplier gain module
improves the performance of RF amplifier.
-
When
OPS1000 has dual channel output, each output level will
reach 110 dB¦ÌV
(pin=1dB, 9dB tilt output at 85~862MHz), when OPS1000 has
quad channel output, each output level will reach 106 dB¦ÌV.
-
When
OPS1000 has single channel output, each output level will
reach 110 dB¦ÌV
(pin=1dB, 9dB tilt output at 85~862MHz), when OPS1000 has
quad channel output, each output level will reach 102 dB¦ÌV.
-
The
reverse optical module, the reverse optical amplifier module
and the duplex filter module are able to be updated on-line.
-
Input optical power test point at
0.2mw/v; LED alarm for optical signal loss, easy to test
optical circuit operation.
-
Optical connection with waterproof; many
forms of ways to connect fibers
-
Aluminum alloy cast shell, housing with
good waterproof, operating outdoor condition.
|
|
|
|
|
